For installers
Qualified and certified
POSID TECHNOLOGIES trains electrical contractors in installing, commissioning and configuring dynamic, multi-dimensional load management — with a certificate at the end.
Why certify?
Load management rarely fails on the hardware
It fails on a mis-parametrised connection limit, on a meter reading the wrong phase, or on a charge point wired up over the wrong protocol. All of that is avoidable — if you know where to look.
The training works through exactly those cases, on real hardware, and ends with a certificate you can show your clients.
Evidence for clients
A certificate proving qualification for § 14a-compliant installations.
Hands-on with real hardware
Controllers, meters and wallboxes to touch, instead of slides.
Less rework
Know the typical commissioning mistakes before they happen in the basement.
A direct line
After the training you know who to call when in doubt.
Curriculum
From the DIN rail to the log
Fundamentals
Connection limits, simultaneity, static versus dynamic load management — and when each one pays off.
Installation
DIN-rail mounting, wiring, current transformers, connecting the ripple-control receiver.
Configuration
Connecting charge points over OCPP and Modbus TCP, parametrising limits, setting priorities and solar surplus.
Operation
Reading logs, isolating faults, updating firmware, evidencing § 14a dimming events.
Run by
POSID TECHNOLOGIES GmbH
POSID sells aCharge and runs the training. Dates, group sizes and content are tailored to your business — on request as an in-house session at your own site.
- Luxemburger Straße 82-86, 50354 Hürth
Next step
Request a date
Tell us how many people should be trained and whether you deploy TELECONTROL, DYLAMO or both — we will come back with dates.
Request training